Heat Pump Installation and Repair in Ft Worth, TX 214-382-9754

Featured

Ft Worth Heat Pump 214-382-9754Finding a trustworthy Ft Worth heat pump repair contractor doesn’t have to be a gamble. Always insist that they have a Texas state license and proof of insurance. Next, look for third party validation. For instance, are they an A+ rated heating and air contractor with the Better Business Bureau? First Call is a contractor that meets these high requirements. Call 214-382-9754 to schedule an appointment today.

Ft Worth Homeowners Want to Know If a Heat Pump Reduce Energy Bills

Modern air to air heat pumps provide efficient heating and air conditioning while maintaining a consistent level of comfort throughout the entire home or office. Heat Pumps are available in a variety of BTU configurations and efficiency ratings.

Upgrading to a 16 SEER (Seasonal Energy Efficiency Ratio) heat pump in your Ft Worth TX home or business should save about 30% on air conditioning costs when compared to a 10 SEER model installed in the early 1990’s. Installing a new heat pump with a higher HSPF (Heating Seasonal Performance Factor) of 7.8 vs. a 6.8 can result in savings up to 20% on your heating utility bill. Newer units are also quieter, control humidity more effectively, and use the more environmentally friendly 410-a refrigerant, too.

Compare a Heat Pump to Air Conditioner For Cooling Your Home

In the summer heating season, a heat pump operates just like a conventional air conditioner. They look the same as far as the outside unit goes. The component that makes a heat pump different from an air conditioner condensing unit is a reversing valve. They have the ability to reverse the flow of the coolant and extract heat from the air in winter months to provide both heating and cooling from a single system.

Comparing Heat Pumps to Furnaces

Natural gas furnaces and heat pumps have comparable operating costs at temperatures above the low thirties. At lower air temperatures, heat pumps lose efficiency Manufacturers install electric heating strips for emergency heat backup in this situation. Electric heat is inefficient and as a result, gas furnaces will heat your home more effectively and at a lower cost at lower temperatures.

HSPF or Heating Seasonal Performance Factor is rating of efficiency of a heat pump. A higher  HSPF rated unit will consume less energy to heat your home.

Geothermal Heat Pumps Growing in Popularity in Ft Worth

You may be asking is geothermal air conditioning and heating a good choice for Ft Worth residents? Yes. With geothermal heat pumps, a series of pipes are buried in the ground. The ground’s constant temperature of 50-55 degrees heat/cools the fluid in the pipe, that runs through the heat pump, to provide heating and cooling in your home.

Heat from the earth is pumped into the building during the heating season. In the summer, heat from the building is transferred to the ground. Geothermal air conditioning and heating is already saving 30% or more on the cost of energy to Ft Worth residents.

Heat Pumps Ft Worth Information

Ft Worth Heat Pumps

Ft Worth Heat Pumps

Ft Worth heat pumps experts want you to know more about these remarkable systems. When you employ an electric resistance heater that consumes one kilowatt-hour of electric energy it only transfers 1 kWh of energy to heat your house at 100% efficiency. In a heat pump, one kWh of energy used in an electric heat pump could “pump” three kWh of energy from the cooler outside air into your home as heat. The ratio of the energy transferred to the electric energy used in the process is called its coefficient of performance (CP). A typical CP for a commercial heat pump is between 3 and 4 units transferred per unit of electric energy supplied.

Heating Season Performance Factor (HSPF) is a measure of the overall heating efficiency of a Ft Worth heat pump. The HSPF can be regarded as an “average” COP of a heat pump for an entire heating season. It is common to compare BTUs of heat output to watts of electrical energy input. HSPF of 6.8 can be compared with an average COP of 2 and a HSPF in the range of 5-7 is acceptable. New heat pumps manufactured after 2005 are required to have an HSPF of at least 7.7. The most efficient heat pumps have an HSPF of 10.

Ft Worth Heat Pumps Brands Repaired and Installed

Trust our Ft Worth heat pump repair team for all brands of equipment including Trane, Ruud, American Standard, Westinghouse, Rheem, Lennox, Carrier, Goodman, Bryant, York, Luxaire, Amana, Tempstar, Coleman, Heil, Comfortmaker, Payne and more.

Ft Worth Heat Pump Repair Service Area

Arlington, Bedford, Blue Mound, Colleyville, Coppell, Euless, Grapevine, Haltom City, Hurst, Keller, Lake Worth,
North Richland Hills, Roanoke, Southlake, Westlake, Trophy Club, White Settlement, Flower Mound, Coppell, Eagle Mountain Lake.

Marietta Electrician